PlaneSpottingWorld welcomes all new members! Please gives your ideas at the Terminal.

Mignet Pou-du-Ciel

From PlaneSpottingWorld, for aviation fans everywhere
Flying Flea series
Avions Henri Mignet H.M. 290 Flying Flea CF-RFH built by John Sayle of Langley BC in 1962 and powered by a 75 hp McCulloch engine.[1] Photographed at the Canadian Museum of Flight.
Type Sport, personal and trainer aircraft
Manufacturer homebuilt aircraft
Designed by Henri Mignet
Maiden flight 10 September 1933 H.M.8 prototype
Introduced 1933
Produced 1933-today
Unit cost USD$350 (in 1933)
US$9,000-$18,000 (H.M. 290E in 2007)[2]
File:AvionsHenriMignetHM1000Balerit13.JPG
Avions Henri Mignet HM1000 Balerit in flight
File:AvionsHenriMignetHM1000Balerit03.JPG
Avions Henri Mignet HM1000 Balerit side view showing wing arrangement

The Flying Flea (Pou du ciel literally "Louse of the Sky" in French) is a large family of light homebuilt aircraft first flown in 1933.

Development

The Flying Flea family of aircraft was designed by French furniture manufacturer Henri Mignet.[3]

Mignet had failed to be accepted as a military pilot and decided to build his own plane. Between 1931 and 1933 he built prototypes in Paris and tested them in a large field northeast of the city. According to his later book, Le Sport de l'Air, he successfully flew the first successful model, HM-14, in September 10 1933. He publicly demonstrated it in 1934 and published the plans and building instructions in a book.

Mignet's original H.M.8 prototype aircraft was powered by a Template:Auto hp Aubier-Dunne 500 cc two stroke motorcycle engine with a chain drive providing a 2.5:1 reduction ratio. It had a a wingspan of Template:Convert, a length of Template:Convert and a gross weight of Template:Auto lb. [4]. It had a usable speed range of 25-62 mph (40-100 km/h).[3]

Design

Mignet made the aircraft intentionally simple. Flying Flea is essentially a highly staggered biplane built of wood and fabric. The original design was single-seater and had a two-axis controls.

The control system was very unconventional. The aircraft had a standard control stick. Fore and aft movement controlled the front wing's angle of attack, increasing and decreasing the lift of the wing. Because the front wing was located forward of the center of gravity this would pitch the nose up and down.[4]

Side to side movement of the stick controlled the large rudder. This produced a rolling motion because the wings both had substantial dihedral, though yaw-roll coupling. The rudder had to be quite large not only to produce adequate roll but also because the fuselage was very short, reducing the leverage of the rudder.[4]

The Flying Flea, being a two axis aircraft, could not be landed or taken off in substantial crosswinds. This was not a big issue when the aircraft was designed because at that time aircraft were usually flown from large open fields allowing all take-offs and landings into wind.[4]

Mignet claimed that anyone who could build a packing case and drive a car could fly a Flying Flea.

Variants

There have more than 300 different models of the Flying Flea.[1] Some of these are:

  • H.M.8 - prototype powered by a Template:Auto hp Aubier-Dunne 500 cc two stroke motorcycle engine, chain drive with a 2.5:1 reduction ratio.[4]
  • H.M.14 - first model described in 1934 to be built by amateurs.[4]
  • H.M.290 - Improved single seater post-war Flea for amateur-construction, usually powered by a Template:Auto hp engine[4][5][2]
  • H.M.293 - single seater for larger pilots usually powered by 50-60 hp VW engine.[5][2]
  • H.M.351 - Post war enclosed cabing Flea with side-by side seating[4]
  • H.M.360 - Post war single seat Flying Flea with improved wing geometry[4][6]
  • H.M.380 - Two seater side-by-side, wood fuselage, 1100 lb gross weight, usually powered by 60-100 hp engine.[6]
  • H.M.380L - Two seater side-by-side, steel tube frame.[6]
  • H.M.1000 Balerit - Improved two seater Flea used by the French Army.

Safety Concerns

In the early days many Fleas crashed when pilots could not recover from shallow dives, resulting in some deaths. As a result the Flying Fleas were grounded and even banned from flight permanently in some countries.[4]

When on approach to land the pilot would push the stick forward to gain speed for the flare and landing. As speed built up the rear wing, operating at a greater angle of attack would gain lift and pitch the aircraft's nose further downward. The pilot's normal reaction would be to pull back on the stick. This action would increase the angle of attack on the front wing by lowering the trailing edge of the wing. Because the trailing edge of the front wing was close to the leading edge of the rear wing the front wing's downwash would accelerate the air over the rear wing and cause it to gain lift more quickly that the front wing, resulting in an ever increasing nose pitch-down and flight directly into the ground.[4]

Mignet had not encountered this problem during his testing of his prototype because he could not afford a large horsepower engine. When builders started putting larger engines on them and expanding the flight envelope the wing interference problem surfaced.[4]

The Royal Aircraft Establishment in the United Kingdom and the French Air Ministry conducted full-scale wind tunnel tests and discovered the problem. Their investigations resulted in changes to the airfoil used and the spacing of the wings to prevent aerodynamic interference. Later Mignet Flea designs incorporated these changes.[4]

By 1939 there were many improved Flying Fleas in the air but the aircraft never completely overcame its dangerous reputation.[4]

Amateur Construction

Shortly after the plans appeared in 1934, many enthusiasts in Europe and the USA began to build their own aircraft. In France there were at least 500 completed. The average cost of materials was then $350.

Modern aircraft enthusiasts have continued to build their own aircraft and vary the original design over the years. French enthusiasts hold an annual meeting every June.

Survivors

File:Flea-bapc43and101.jpg
HM.14 Flying Flea at the Newark Air Museum, England

The Shuttleworth Collection (UK) has an example in its collection of historic aircraft, powered by a Bristol Cherub engine. There is also an HM.14 Flying Flea, G-AEGV in the Midland Air Museum, Coventry, England. Other sites include the Yorkshire Air Museum, Newark Air Museum.

Specifications (H.M. 290 Flying Flea)

Data from Plane and Pilot: 1978 Aircraft Directory[3]

General characteristics

  • Crew: one pilot
  • Length: 14.0 ft (4.27 m)
  • Wingspan: 20.0 ft (6.1 m)
  • Height: ()
  • Empty weight: 410 lb (186 kg)
  • Max takeoff weight: 700 lb (317 kg)
  • Powerplant: 1× McCulloch , 72 hp (54 kW)

Performance


References

  1. 1.0 1.1 Canadian Museum of Flight (2006). Mignet Pou du Ciel (Flying Flea). Retrieved on 2007-12-30.
  2. 2.0 2.1 2.2 Kitplanes Staff: 2008 Kit Aircraft Directory, page 53, Kitplanes Magazine December 2007 Volume 24, Number 12, Belvior Publications, Aviation Publishing Group LLC.
  3. 3.0 3.1 3.2 Plane and Pilot: 1978 Aircraft Directory, page 142. Werner & Werner Corp, Santa Monica CA, 1977. ISBN 0-918312-00-0
  4. 4.00 4.01 4.02 4.03 4.04 4.05 4.06 4.07 4.08 4.09 4.10 4.11 4.12 4.13 Peter M Bowers: Guide to Homebuilts - Ninth Edition, Chapter 7 Shattered Dreams, pages 73-78. TAB Books, Blue Ridge Summit PA, 1984. ISBN 0-8306-2364-7
  5. 5.0 5.1 Falconar, Chris (June 2007). MIGNET "Flying Flea". Retrieved on 2007-12-30.
  6. 6.0 6.1 6.2 Falconar, Chris (June 2007). MIGNET HM 360/380. Retrieved on 2007-12-30.
  • The Flying Flea: How to Build and Fly It, Henri Mignet
  • Henri Mignet and his Flying Fleas, Ken Ellis & Geoff Jones (Out of print)
  • Le Sport D'Air Henri Mignet (FR.661 pages)

External links

de:Himmelslaus fr:Pou-du-ciel ja:プー・ド・シェル (航空機) fi:Mignet HM-14 Pou du Ciel


This article is licensed under the GNU Free Documentation License.
It uses material from the Wikipedia article "Mignet Pou-du-Ciel".